Repair Service Manual

REPAIR MANUAL
8
ELECTRICITY-INSTRUMENTS
CENTRALIZED LOCKING
CONNECTION
USING A REMOTE CONTROL
BUTTON 1
LOCKING: Press this button once: the doors are locked, the
indicators flash once.
BUTTON 2
DOOR UNLOCKING: 1 short pulse (< 1.5 s), the doors are
unlocked, the indicators flash twice.
Ref: 8AG101
REMOTE CONTROL PROGRAMMING TABLE
Please apply the procedure below to enter the programming mode:
• A • Insert the key into the Neiman
• B • Turn the key 5 times from the OFF position to the Contact (Ignition) position. Switching from
OFF to contact must be performed in less than 3 s. At the last key turn, stay in the Contact
position for 3 s.
• C • The indicators will then be lit for 2 s.: programming a remote control
Please refer to the table below to program a remote control:
N Number
of key
turns
Programmabl
e function
After the N key turns, the indicators flash:
3 TIMES
5
Coding a
remote control
1 • After the 5th key turn (key on ACC) the indicators are lit steady for 2 s.
2 • Before 10 s., press the remote control you wish to code on the vehicle.
3 • The indicators flash twice to validate this new remote control.
4 • Restart the operation for the other remote controls before 10 s.
5 • After 10 s. (or key set to OFF), you quit the programming mode, the indicators
flash 3 times.
1. +12V locking output
2. +12V power supply input
3. Ground input
4. +12V unlocking output
5. +12V after-contact input
6. +12V indicator output
7. +12V indicator 2 output
BUTTON 1
BUTTON 2