Repair Service Manual

REPAIR MANUAL
8
ELECTRICITY-INSTRUMENTS
CHANGING A LAMP
Changing a lamp on a light
Old model New model
1. Position light lamp
- Swivel the lamp holder by a quarter turn to the left and pull it out.
- Remove the lamp by pulling to change it.
- Refit the lamp holder while ensuring the locating pins (one large, one small) is opposite the
corresponding notches on the back of the projector.
- Turn it by a quarter turn to the right while pressing it to push the seal.
2. Low beam, high beam lamp
- Remove the headlight cover. To unlock, press the upper clip and remove it.
- Remove the sealing lens on the rear face of the headlight and pull on it to remove it from the
lamp socket.
- Press the lamp locking wire by sliding it to the right and lowering it.
- Pull out the lamp.
- Refit the new lamp while ensuring its spigots enter their housings (do not touch the glass part of
the lamp with your fingers).
- Fold its locking wire and press it by sliding it to the left.
- Reposition the sealing lens onto the lamp socket.
- Engage the lens on the rear face of the headlight.
- CAUTION: do not omit the two previous operations, otherwise water may enter the headlight
and damage it.
- Engage the protection cover on the seal while ensuring the cut for passing the electric harness is
vertical, otherwise the clip cannot be engaged and you may lose the cover.
3. Indicator light lamp
- Swivel the lamp holder by a quarter turn to the left and pull it out.
- Press the lamp by pivoting it to the left and pull it out.
- Fit the new lamp onto the holder by aligning the spigots facing the cuts in the holder, press the
latter while turning it to the right.
- Refit the lamp holder onto the headlight while positioning its spigots (one large, one medium,
one small) opposite the appropriate cuts in the headlight.
- Press the lamp holder and turn it by a quarter turn to the right