Repair Service Manual

REPAIR MANUAL
3
REGULATOR ASSEMBLY
IMPORTANT NOTE
All installation, servicing and repair operations must be performed only by skilled
personnel.
 This symbol identifies operations with a risk of severe injury if the instructions are not
observed.
 This symbol identifies a step with a risk of damaging parts or malfunction of the
components.
 CVTech waives any liability for any damage or injury resulting from bad comprehension of
the text, inappropriate use of the regulator or the tools recommended.
 The tightening torques indicated must be observed rigorously.
SERVICING FREQUENCY
The regulator requires no lubrication. It is designed to run dry. Hence, certain cleanliness rules are
applicable upon handling to prevent contact of any products with the regulator components.
To increase the lifetime of the regulator, we recommend performing the following checks:
Description
Check
Periodicity
Leading pulley
Visual / General condition
10,000 km
Fixed flange
Visual
10,000 km
Sliding flask
Visual
10,000 km
Assembled centrifugal block
Visual
10,000 km
Lower main bearing
Visual
10,000 km, change
Spring
Visual
10,000 km
Upper main bearing
Visual
10,000 km, change
Led pulley
Visual / General condition
10,000 km
Fixed flange
Visual
10,000 km
Sliding flask
Visual
10,000 km
Cam slider
Visual / Dimensional
10,000 km
Spring
Visual
10,000 km
Belt
Visual / Dimensional
10,000 km