Repair Service Manual

REPAIR MANUAL
3
REGULATOR ASSEMBLY
INSTALLING PULLEYS ON THE VEHICLE
First of all:
 For a initial fitting on the vehicle, the installer must have the layout drawing. This drawing
includes all specifications of the vehicle, the numbers of the pulleys and belt, as well as the
dimensional geometry of the complete assembly.
 Cleanliness is required on all components.
 No lubrication product must be used.
Installing the led pulley
Fit the led pulley (7) onto the gearbox
shaft (2) while adding the key (6).
Installing the leading pulley and the belt
To ensure easier fitting of the leading pulley and belt, an opening screw no. 0080-0055 (M6x1.0)
may be used to open the flasks of the led pulley, and hence loosen the belt.
Fit the leading pulley (3) by passing it in the belt (10) and then onto the flywheel shaft (1).