Repair Service Manual

REPAIR MANUAL
3
REGULATOR ASSEMBLY
Refitting the leading pulley
Refitting the sliding flange
Refitting the sliding flange is performed by reversing the removal sequence (see removing the
sliding flange).
Please note to return the spacing washers to their original position.
Refitting the fixed flange
To refit the flange, we recommend using a press and a tube 32 mm inner diameter and length 125
mm.
As per the illustration:
-Insert the bearing (1a).
- Insert the tightening ring (1b)
Ensure you have perfect contact between the shaft shoulder, bearing and tightening ring
without applying pressure with the press to prevent damaging the components.
Before fitting the sliding flange (3) onto the fixed flange (1),
it is important to fit the spacing washer (2).