Repair Service Manual

REPAIR MANUAL
8
ELECTRICITY-INSTRUMENTS
Description of input and output connectors and signals:
There are three connectors, J1, J2 and J3.
J1 30-pin connector:
MOLEX connector
Or
FRAMATOME connector
PIN-1: Free
PIN-2: NEUTRAL input (see AGB function)
PIN-3: ENGINE TEMPERATURE CTN gauge input (Diesel preheating)
PIN-4: FUEL gauge input
PIN-5: WARNING switch input (Activated by ground connection)
PIN-6: POSITION LIGHTS input (Activated by connection to positive)
PIN-7: Positive input of the KEY
PIN-8: DEFROSTING switch input (Activated by ground connection)
PIN-9: LEFT INDICATOR input (Activated by ground connection)
PIN-10: Ground (-) for SPEED SENSOR
PIN-11: Free – Not used on this model
PIN-12: REAR FOG input (Activated by connection to positive)
PIN-13: LOW BEAM input (Activated by connection to positive)
PIN-14: HIGH BEAM input (Activated by connection to positive)
PIN-15: BRAKING input (Activated by ground connection)
PIN-16: Free
PIN-17: OIL TEMPERATURE input (Activated by ground connection)
PIN-18: AGB_REVERSE input (see AGB function)
PIN-19: Do not use – Do not connect cable – Private use of FACOMSA
PIN-20: RIGHT INDICATOR input (Activated by ground connection)
PIN-21: SPEED SENSOR pulse input (Input of open manifold type)
PIN-22: Ground (-) for OUTSIDE TEMPERATURE CTN gauge
PIN-23: Supply (+) for SPEED SENSOR.
PIN-24: Free
PIN-25: BATTERY CHARGE input (Activated by ground connection)
PIN-26: Input (+) OUTSIDE TEMPERATURE CTN gauge
PIN-27: Ground (-) for FUEL gauge
PIN-28: DOOR input (Activated by ground connection)
PIN-29: BRAKE PADS input (Activated by ground connection)
PIN-30: Free – Not used on this model