Installation Guide

4
SETUP
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE WAY AND IN
ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment that will not be used for an extended
period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only batteries of the
same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new
batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.
Power the Unit ON/OFF
The wireless display and thermometer base will automatically power off after 24 hours of
inactivity. To power off manually, press and hold the “POWER” button for 3 seconds.
Using the Thermometer
1. Before operating, plug the temperature probes into the thermometer base.
2. Once batteries are installed, the LCD display will automatically turn on.
3. Press and release the “SET” button on the wireless display to cycle through the
setup modes at any time.
Select Temperature Units
To select between degrees Fahrenheit (ºF) or Celsius (ºC) temperature units, slide the
“F/C” switch, located in the battery compartment of the thermometer base.
Wireless Display Setup
1. Slide off the battery compartment
cover (not shown).
2. Insert 3 x AAA batteries into the
battery compartment. Follow the
polarity (+/-) diagram in the
battery compartment.
3. Replace the battery cover.
Install or Replace Batteries
AcuRite recommends high quality alkaline batteries for the best product
performance. Heavy duty or rechargeable batteries are not recommended.
1. Slide off the battery compartment
cover (not shown).
2. Insert 2 x AAA batteries into the
battery compartment. Follow the
polarity (+/-) diagram in the
battery compartment.
3. Replace the battery cover.
Thermometer Base Setup