Installation Guide

ManualsBrandsAcuRite ManualsGrill AccessoriesDigital Meat Thermometer with Wireless Display and Time Left to Cook

Backlight

Wireless Display: Press and release any button to momentarily illuminate

the display for 10 seconds. From normal operation mode, press and HOLD the

◄ and ► buttons simultaneously for 5 seconds to keep display illuminated.

Display will remain illuminated until those steps are repeated, or the batteries

are removed.

Thermometer Base: Press and hold the “BACKLIGHT” button for 5 seconds

to activate the backlight. Display will remain illuminated until those steps are

repeated, or the batteries are removed.

3. Once cooking begins, the rising temperature automatically prompts the

wireless display to calculate estimated cook time. The display shows rotating

dashes during the calculation process. Once the internal food temperature

reaches 105°F (41°C), the calculation will be displayed.

4. When estimated time left to cook expires (or reaches 0:00), an audible beep

sounds on the wireless display. In most cases, time left to cook automatically

adjusts for changes in the cooking process, however the following actions

may impact its accuracy:

•Removing food from the oven

•Adding cool liquids to cooking food

•Changing the oven temperature during cooking

•Disconnecting or removing the probe during cooking

•In some cases, basting

If you feel Time Left to Cook estimation has been compromised, reset the

wireless display by pressing and holding the “POWER” button to power OFF

and press again to power back ON.

Warning Messages

When the wireless display reads “LOW

BAT”, replace batteries. Display will

indicate whether the base and/or the

display require new batteries.

Check Probe

“CHECK PROBE” indicates a probe error and is shown with a diagnostic code:

Diagnostic Code Problem Solution

Probe cord is not connected to the

wireless display.

Verify cord connection is

secure or reconnect cord.

Probe cord is not functioning properly.

Cord may have been damaged or

exposed to extreme heat.

Check the wire and

connection for damage or

excessive heat. Replace cord.

RARE MEDIUM WELL

TARGET

TEMP

hrs.

min.

sec.

low bat