Troubleshooting guide

PROGRAM STEPS
MILLPWR
®
Operation Manual
5-7
Center Line
With the position/drill feature, you can also locate the midpoint of two points or the
center line of a circle.
T
o locate a center line:
• Press the CENTER LINE softkey.
• Locate the first edge then press the
ENTER key.
• Locate the second edge of your part then press the ENTER key.
• If you're calculating the center of a circle, locate then enter three
points along the diameter of the circle.
• Press the
USE key.
If you use an
electronic edge
finder, the points
will automatically
be entered on
contact—even if
you over-travel.