Troubleshooting guide

PROGRAM STEPS

MILLPWR

Operation Manual

5-8

Line

Lines are defined by their “From” point (the point where they begin) and “To” point (the

point where they end).

There are two ways you can program a line:

• With four coordinates (X1, Y1, X2, Y2)

• With three of the coordinates above (X1, X2, Y2 or X1,

Y1, X2, etc.) and an angle

Choose a method based upon the information available from your print.

o program a line:

• Press the LINE key.

• Enter the beginning X- and/or Y-axes coordinates into the

“From” field.

• Enter the ending X- and/or Y-axes coordinates into the “To”

field.

• Enter the begin and end depths for the Z-axis.

• Enter the Z-axis feed rate.

• If one of the X- or Y-axes fields above was left blank, enter an

angle.

• Highlight the "Offset" field and press the

LEFT, CENTER, or

RIGHT softkey.

• Enter the table’s feed rate.

• Press the

USE key.

Note:

If the tool size and type listed in the "Tool" field are incorrect, change the tool

settings before running your program (refer to Programming a Tool Step).