Troubleshooting guide

PROGRAM STEPS

MILLPWR

Operation Manual

5-19

• Enter the Z-axis feed rate.

• Select a tool offset by pressing the appropriate softkey.

• Enter the table’s feed rate.

• If you wish to program a 2

Corner and/or a tilt angle or

would like to program a finish cut, press the

MORE softkey.

Corner

Enter the X- and Y-axes coordinates for the 2

Corner.

(The 2

Corner must be located diagonally across from

the 1

Corner.)

Tilt Angle

Enter the tilt angle.

Finish

Enter a stepover percentage (how much you want your tool to overlap on each

pass).

• Press the

USE key.

Note:

If the tool size and type listed in the "Tool" field are incorrect, change the tool

settings before running your program (refer to Programming a Tool Step).