Troubleshooting guide

PROGRAM STEPS
MILLPWR
®
Operation Manual
5-29
• If you need to program a start angle and/or a number of
revolutions, press the
MORE softkey.
Start Angle
Enter the angle where the helix begins (3 o’clock
position is 0 degrees; 12 o’clock position is 90 degrees).
Revolutions
Enter the number of revolutions.
• Press the
USE key.
Note:
If your tool size and type listed in the "Tool" field are incorrect, change the tool
settings before running your program (refer to Programming a Tool Step).