User's Manual

RX INN Installation Guide Page: 17
Software Configuration
Overview
The RX INN cannot be used in a standalone environment and requires the Intelligent Network
Server (INS) for operational use. The RX INN is configured with a basic operating system
that enables it to search out a connection to an INS so that it may download it’s configuration
and operational software for network use.
The RX INN will be delivered in Configuration Mode so that customers may make a web
based connection to the unit for correct operation within their environment. Unless otherwise
directed at the time of ordering no other configuration of the unit will be made.
The installation process below should be followed to enable the RX INN to boot a suitable
configuration once the INN has been built in the RAMP software.
Configuring RX INN
Connecting a PC
1. Plug an Ethernet cable into the RX INN Eth 1 port and then into the network port of
the PC (a normal or cross over cable can be used).
2. Go to the Network Configuration.
3. Select Properties on the Local Area Connection and then the Properties on the
TCP/IP option.