User's Manual

RX INN Installation Guide Page: 2

reproduced or disclosed in whole or in part by any means without the written consent of

aCure Technology Pty Ltd.

All other trademarks and brand names are marks of their respective holders.

FCC Notice

RX INN FCC Number: UWT-RX-4002-02

The enclosed wireless network device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may

cause undesired operation.

This wireless network device has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This wireless

network device generates, uses, and radiates radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this wireless network device does cause harmful interference to radio

or television reception, which can be determined by turning the wireless network device off

and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

1. Reorient or relocate the receiving antenna.

2. Increase the separation between the wireless network device and the affected

receiver.

3. Connect the wireless network device into an outlet on a circuit different from that to

which the receiver is connected.

4. Consult the dealer or an experienced radio/TV technician for help.

Limited Warranty Notice

Hardware: aCure Technology warrants all supplied equipment (INN, INS, IGS and

accessories), for the term of one year from the shipping date to be free of defects in materials

and workmanship under normal use and service. All parts will be repaired or replaced with

similar or functionally equivalent parts by aCure Technology during the warranty term, except

in case the returned parts have mechanical, electrical or other accidental or intended

damages caused by improper use or due to wind, rain, fire or other acts of nature.

Parts (or systems) must be shipped pre-paid to our facility in Perth, Australia. All items must

have a Return Authorisation (RA) number which you can get by contacting us via email,

telephone or fax. The RA must be printed, signed, and enclosed with the shipment, also the

RA number must be written on the package itself. Parts sent without following the proper

procedure will be treated as those not to be repaired or replaced due to the above mentioned

conditions. Items proved to be free of defects in our lab will be returned to the customer at the

customer's expense. Those that do meet the warranty repair requirements will be repaired or