User's Manual

Acurix Networks - User Manual X2-A

Page 28 of 31

authentication occurs. Valid ranges are from 0 to 65535

seconds. The value that you set goes into effect after you

reboot your computer with this profile set as the active

profile. This drop-down menu is active only if you chose

EAP-based authentication.

6. Select Advanced tab.

Transmit Power Level Selects the transmit power level for 80211b/g or 802.11a

in mW. Actual transmit power may be limited by

regulatory domain or hardware limitations. Also note that

administrator has the privilege of locking these power

levels, so that these values are pre-selected and not

editable.

Power Save Mode Specify:

• Maximum mode causes the access point to buffer

incoming messages for the wireless adapter. The adapter

periodically polls the access point to see if any messages

are waiting.

• Normal uses maximum when retrieving a large number

of packets, then switches back to power save mode after

retrieving the packets.

• Off turns power saving off, thus powering up the

wireless adapter continuously for a short message

response time.

Network Type Specifies the network as either infrastructure (access

point mode) or ad hoc.

Wireless Mode Specifies 5 GHz 54Mbps, 5 GHz 300Mbps, 2.4 GHz 54

Mbps, 2.4 GHz 11Mbps, 2.4 GHz 300Mbps or Quality of

Service operation in an access point network.

The wireless adapter must match the wireless mode of

the access point it associates to.

Wireless Mode when Starting Specifies 5 GHz 54 Mbps, 5 GHz 108 Mbps, or 2.4 GHz an

Ad Hoc Network 54/11 Mbps to start an ad hoc network if no matching