User's Manual

Acurix Networks - User Manual X2-A

Page 30 of 31

7. Select “TCP/IP Property” tab. Enter the settings and click “OK” to save the settings.

 If the network uses DHCP server, choose Obtain an IP address automatically.

 If the network does not use DHCP server, choose Use the following IP address to set the relative

settings. For the IP configuration information, please contact the network administrator.

5.3 Default Settings Windows XP Zero-Configuration

You may also choose the default parameters and directly proceed to Windows XP zero-configuration

through the steps below:

1. Go to “Control Panel” and open “Network Connections”.

2. Right-click the Wireless Network Connection of “WLAN a/b/g/n mini-card Module”, and make sure

this connection is Enabled.

3. Right-click the Wireless Network Connection of “WLAN a/b/g/n mini-card Module”, and then click

“Properties”.

4. Select “Wireless Networks” tab and select “Use Windows to configure my wireless network

settings” check box.

Note: Clear the check box of “Use Windows to configure my wireless network settings” will disable

automatic wireless network configuration.