Specifications

EN • 27
ENGLISHFRANCAISNEDERLANDSESPAÑOLITALIANODEUTSCH
664Y3000.A
MCBA PARAMETERS FOR THE SPECIALIST
Factory setting
Key Screen Description of parameters Prestige 50 Prestige 75
STEP
Re-modulate the difference T1 - T2
STEP
Shell address
[-1 = disabled]
STEP
Temperature increase set point
for the production of hot water
STEP
first position:
2nd heating circuit:
0 = disabled
1= enabled [slave]
2 = enabled [master]
Second position:
the demand for heat comes from:
0 = the room thermostat
1 = the outdoor sensor
STEP
First position: Domestic hot water pump [1] or
three-way mixer tap [2]
Second position: tank with NTC3 probe [2] or
tank with thermostat (3)
STEP
Manual fan number of revolutions
STEP
First position:
Fan control pump level
during burning in
Second position:
Fan control pump level
+during over-run time
STEP
Hold temperature
STEP
Maximum temperature for the start heating
curve for the 2nd circuit
STEP
Minimum temperature for the start heating
curve for the 2nd circuit
STEP
2nd circuit temperature hysteresis
STEP
First position: Special pump
[0 = disabled]
Second position: Minimum disable cycle
[0 = disabled]