Installation manual

Page 16
Audio Input Jack Assignment
The Cinema Rhapsody Mach 4 makes it possible
to assign any audio and video jack to an Input
Label. For audio, there are:
3 TOS-Link Optical inputs,
5 digital coax inputs
8 analog audio inputs
An 8-channel bypass input
8 HDMI inputs (A/V)
When using an HDMI interconnect, you may still
opt to use any one of the other audio inputs. If
you want to extract the audio for that source from
the HDMI input used for video, instead of selecting
a digital or analog audio input, select HDMI. The
Input Label will then select the audio associated
to the HDMI input.
To change the Audio Input, rst select the input
you wish to setup. With the cursor on the I in IN-
PUT, turn the input knob until the desired INPUT
# is displayed. The turn the Mode knob so that
the cursor is under the letter A in Audio. Turn
the Input knob until the connection you require is
displayed. In this example, we want to alter the
SATELLITE input from HDMI to OPTICAL 1.
In the PC program, pull down on the rst window
to the left of the Input Label (source name) and
select the audio jack.
Note - If you are looking to extract audio present
on the HDMI cable, the audio option must be
HDMI.
Note - Changes are not effected until you have
performed a LOAD.
To assign audio jacks for other Input Labels, turn
the Mode knob so that the cursor is sitting under
the I in the word INPUT. Then turn the Input Knob
to select the desired input number. Repeat the
above steps.
Since several other features also need to be
“loaded” it is useful to set these rst. As such, you
will save time loading parameters such as Video
Input Jack Assignment, Input Presets, and Default
Modes. If you do not intend to change these other
settings and wish to simply Load the Input Labels
now, proceed to Loading Input Parameters.