Installation manual

Page 36
Tone Settings & Loudness On/Off
The Cinema Rhapsody Mach 4 features a loud-
ness contour lter and parametric tone control
(where in you can adjust Bass and Treble Levels
as well as set a Frequency points for both bass
and treble).
To turn Loudness on or off, press the button.
To set the Tone Controls using the PC program,
select the Tones tab and then either Group A or
B. Here speakers are toggled into or out of a
group. You can also raise or lower the frequency
points and levels for both bass and treble. There
are two speaker groups - Group A and Group B.
In each group, you can determine which speak-
ers track that group (are affected by that group’s
bass and treble levels). Speakers can be in one
group or another, both groups or neither. There
are four Tone Presets that are saved by simply
Storing the preset while the audio levels are in
use. The preset not only stores levels and fre-
quency points, but also which speakers are ac-
tive in both Speaker Group A and B. If your front
speakers are one design while the surrounds are
another, you can place each in their own group.
If you are looking to EQ just the left and right
across two frequency points include them in both
groups while excluding all other speakers. If you
want to just correct the subwoofer, include it in
both groups while excluding all other speakers.
For Loudness, from the front panel of the Cinema
Rhapsody Mach 4 while in the Setup Mode turn
the Mode knob to navigate to VOL SET and then
press the Mode knob. Use the Mode knob to
navigate to LOUDNESS and the Input knob to
turn it ON or OFF.
For Tones, from the front panel of the Cinema
Rhapsody Mach 4 while in the Setup Mode turn
the Mode knob to navigate to TONE SET and then
press the Mode knob. Turning the Mode knob
will rst scroll through channels. To engage the
channel into or out of the current speaker GROUP
(A or B), press the Mode knob (the channel will
show or disappear). To change Treble, Bass, or
their Frequency, turn the Mode knob to the desired
feature and adjust by turning the Input knob. To
Store or Recall a preset, turn the Mode knob to
that feature and then turn the Input knob to select
the desired preset number. Press the Input knob
to store or recall the desired Tone Preset.