Owner`s manual

MIDI
SELECT MIDI CHANNEL
1. Press the MIDI CHNL button on the front panel of your MP-1. It will light up.
2. Use the up or down arrow buttons to select MIDI channel 1 on the display.
3. When the number 1 is displayed, press the MIDI CHNL button to store your selection
and exit the MIDI channel edit mode.
4. Assign your MC-1 MIDI controller, and any connected MIDI effects to MIDI channel 1.
OPTIONAL MC-l REMOTE
The ADA MC-1 is a universal MIDI FOOT CONTROLLER that permits sending program
change commands to the MP-1 and the rest of your MIDI equipment
MIDI MAPPING
The MIDI mapping feature allows you to "translate" any MIDI program change number
received at the MP-1's MIDI IN port to another MIDI program change number (1-128).
The MP-1 will respond by changing to the mapped program number. The MP-1'sMIDI OUT
port will transmit the mapped program change number to subsequent connected MIDI
devices. The MP-1's MIDI THRU port will transmit the original un-mapped MIDI program
change number received at the MIDI IN port to subsequent connected MIDI devices.
1. Using BANK, up/down arrows, and 0 to 9 buttons, select the MIDI program change
number (1 to 128) to be mapped or "translated".
2. Press the MEM button.
3. Using BANK, up/down arrows, and 0 to 9 buttons select the mapped MID I program
change number (1 to 128). This is the number which the MP-1 will change to and
transmit through the MIDI OUT port. You may map multiple program change numbers
to a single mapped program change number.
ONE-TO-ONE MIDI MAPPING
The MP-1 is shipped from the factory with a one-to-one mapping assignment, i.e. MIDI
program change number 1 received at the MIDI IN port will change the MP-1 to program
number 1, program change 2 will change the MP-1 to program 2, etc. If you want to restore
the one-to-one relationship:
1. Press the STORE button. It will light.
2. Press the BANK button and while holding down the BANK button press the number 2
button.
3. The display will read "1 to 1 Loaded." When the display returns to a program number,
the one to one mapping assignment is complete.
Note: restoring one-to-one mapping will erase all previous MIDI mapping assignments.
MIDI SYSTEM EXCLUSIVE
The MP-1's System Exclusive Save and Load features allow you to save and load programs
to and from disk. In order to use these features you must have a computer with a MIDI
interface and MIDI software which supports standard MIDI file save/load, or a MIDI
sequencer that supports standard MIDI file save/load. You can down-load or up-load one
program at a time or the MP-1's entire internal memory. When you have completed
programming your MP-1 we recommend you back up your work by saving it to disk.
In order to use the save and/or load feature you must connect MIDI cables from the MP-1
MIDI IN and MIDI OUT to the appropriate MIDI IN and MIDI OUT ports of your
computer/sequencer. NOTE: To avoid MIDI feedback disable MIDI ECHO/PATCH THRU on
Page 9