Owner`s manual

PRECAUTIONS
WARNING:
To prevent fire or shock hazard, do not expose this appliance to rain or moisture. Locate the
MP-l out of direct sunlight. Avoid locations subject to vibration, excessive dust, heat, or cold.
CAUTION:
To prevent electric shock, do not remove cover. No user serviceable parts inside. Refer
servicing to qualified service personnel.
RETAIN INSTRUCTIONS:
Keep this manual for future reference.
CLEANING:
Do not clean your MP-1 with chemical solvents. Use only a clean, dry cloth.
QUICK START GUIDE
Note: The MP.1 is a preamp and must be connected to a power amp in order to drive loud
speakers.
INITIAL PREPARATION:
1. Connect guitar output to front or rear panel input jack.
2. Connect MP-1 output(s) to input(s) on power amplifier.
3. Connect power amp output( s) to speaker cabinet(s) input(s), Note: use speaker
cable(s) for this connection.
4. Turn power switch ON.
5. Adjust volume with Output level control.
SELECT PROGRAM NUMBER:
1. Use the up and down arrow buttons to scroll thru the memory numbers 1 thru 128.
2. Select a bank by pressing the BANK button, use the up or down arrow button to
select bank 0 thru 12, followed by any button 0 thru 9 for program number within the
selected bank.
SELECT MIDI CHANNEL:
1. Press MIDI CHANNEL button.
2. Use up and down arrows to select MIDI channel from 1 to 16, ALL (OMNI), or OFF
(MIDI reception off).
3. Press MIDI CHANNEL button to store channel selection and exit to play mode.
Page 4