Owner`s manual

To move between parameter screens:
• Press the ">" button repeatedly to reach a following screen; after stepping
through all the parameters on the current screen, the next button press will
step to the next screen.
Similarly, the left arrow button is pressed repeatedly to reach preceding
screens.
To adjust the value of the selected parameter:
• Use the "∧" and "∨" buttons (up and down arrow) to modify the value of the
selected parameter.
Each time one of these buttons is pressed, the value is increased or decreased by one. If the
parameter is not a number but a toggle, or switch-type of setting that only has two values,
the up and down arrow buttons are used to change from one value to the other. These
buttons are also used to answer Yes/No questions the MP-2 sometimes displays.
• Hold down either button to cause the selected parameter to scroll, or
automatically count, up or down through its entire range of available values.
To edit a program in Program Edit mode:
1) Press the Select button of the section you wish to edit. The LED in the button
will illuminate
2) Use the < and > (left and right arrow) buttons to move the cursor to the
parameter to be adjusted.
3) Use the ∧ and ∨ (up and down arrow) buttons to change the value of the
parameter. Changes made to a parameter are always heard immediately.
4) Repeat steps 1 through 3 until all parameters have been adjusted as desired.
5) Store the program.
NOTE: Pressing the "A" and "v" buttons simultaneously sets the selected parameter to
the factory default value.
Page: 21