Datasheet

This sketch will not write any data to the card, just tell you if it managed to recognize it, and

some information about it. This can be very useful when trying to figure out whether an SD

card is supported. Before trying out a new card, please try out this sketch!

Go to the beginning of the sketch and make sure that the chipSelect line is correct, for the

datalogger shield we 're using digital pin 10 so change it to 10!

If you have the pre-rev B version of the Datalogger Shield, and you are using a Mega or

Leonardo check here for now to adjust the pin setup (http://adafru.it/ref)

OK, now insert the SD card into the Arduino and upload the sketch