Datasheet

Install the Jumpers
Place the jumpers as shown, with
the long stripped ends nearest
the sensors.
Since there are no signal traces
between the holes in the
prototyping area, we will use the
long stripped ends to join the legs
of the components on the board.
Make the
connections
Solder the first jumper (red)
to the 3v hole.
Bend the stripped end of
the wire so it rests next to
the legs of the light sensor,
the temperature sensor and
the end of the AREF
jumper.
Fold the sensor legs and
AREF jumper legs over the
3v jumper and solder to
make the connection.
© Adafruit Industries https://learn.adafruit.com/adafruit-data-logger-shield Page 56 of 85