Datasheet

The hard part's done! Now we can solder
on regular 0.1" spaced male header. We
like the break-away kind so its easy to
get just the right amount. (You can get
some at the adafruit shop if you don't
have any!) (http://adafru.it/392)
Break two pieces the same length as the
pads on either side of the PCB and place
them into a breadboard, long pins down.
They should be parallel and the same
distance as the PCB pads so that you can
place the PCB on top with ease
Almost done, now all you have to do is
solder each header pin into the
corresponding hole to make a secure
connection
© Adafruit Industries Last Updated: 2013-03-31 09:30:21 PM EDT Page 8 of 8