Datasheet

the sides are at right angles. The material is not important as long as it is fairly rigid.

Load the Calibration Sketch:

Load and run the Calibration sketch below. Open the Serial Monitor and wait for the prompt.

Position the Block:

Place the block on a firm flat surface such as a

sturdy table. Type a character in the Serial

Monitor and hit return. The sketch will take a

measurement on that axis and print the results.

Reposition the Block:

Turn the block so a different side is flat on the

table and type another key to measure that

axis.

(http://adafru.it/c5g)

Repeat:

Repeat for all six sides of the block to measure

the positive and negative aspects of each axis.