Datasheet

Add the Breakout:

Align the breakout board and place it over the

header pins on the breadboard.

And Solder!

Be sure to solder all pins to assure good

electrical contact.

I2C Wiring:

The ADXL345 Breakout has an I2C address of 0x53. It can share the I2C bus with other I2C

devices as long as each device has a unique address. Only 4 connections are required for

I2C communication:

GND->GND

VIN->+5v

SDA->SDA (Analog 4 on "Classic Arduinos")

SCL->SCL (Analog 5 on "Classic Arduinos")

The Adafruit breakout has level shifting and regulation circuitry so you can power it from 3-

5V and use 3V or 5V logic levels for i2c