Datasheet

Each order comes with one assembled and tested shield, a stick of 0.1" male header and a 12mm

coin cell. Some light soldering is required to attach the header to the shield in order to plug it into

your Arduino. if you want to stack a shield on top, be sure to pick up a set of stacking headers to

use instead.

If your project is going to be inside an enclosure, you'll love this shield as it has external antenna

support. Simply connect an external active GPS antenna (http://adafru.it/960) via a uFL/SMA

cable (http://adafru.it/851) to the shield and the module will automatically switch over to use the

antenna. You can then place the antenna wherever you wish.

We think this is the Ultimate GPS shield and we also think you'll agree!