Datasheet

Preparation

This tutorial assumes you have your Pi mostly set up and have followed our "Raspberry Pi as Wifi Access Point" tutorial

Please follow these tutorials in order to

Install the OS onto your SD card (https://adafru.it/aWq)

If you bought an SD card with Raspbian pre-burned on you can skip this step

Boot the Pi and log into it (https://adafru.it/aUa)

Don't forget to change the default password for the 'pi' acccount!!!

Make sure to expand the filesystem to the entire disk or you may run out of space (this is done by default now on

Raspbian when you boot it)

However, don't configure WiFi - you can log in over Ethernet or Serial console

Set up and test the Ethernet connection - in general this means just plug into Ethernet before

booting (https://adafru.it/aUB)

Check that you can ssh to, or ping from the Raspberry Pi

For WiFi, you do not need to configure anything. and that your Wifi adapter is recognized and shows up as wlan0

when you run ifconfig wlan0