Data Sheet

a-Si TFT LCD Single Chip Driver
240RGBx320 Resolution and 262K color
ILI9341
The information contained herein is the exclusive property of ILI Technology Corp. and shall not be distributed,
reproduced, or disclosed in whole or in part without prior written permission of ILI Technology Corp.
Page 112 of 233
8.2.21. Page Address Set (2Bh)
2Bh PASET (Page Address Set)
D/CX RDX WRX D17-8 D7 D6 D5 D4 D3 D2 D1 D0 HEX
Command 0 1 ↑ XX 0 0 1 0 1 0 1 1 2Bh
1
st
Parameter 1 1 ↑ XX
SP15 SP14 SP13 SP12 SP11 SP10 SP9 SP8
2
nd
Parameter 1 1 ↑ XX
SP7 SP6 SP5 SP4 SP3 SP2 SP1 SP0
Note1
3
rd
Parameter 1 1 ↑ XX
EP15 EP14 EP13 EP12 EP11 EP10 EP9 EP8
4
th
Parameter 1 1 ↑ XX
EP7 EP6 EP5 EP4 EP3 EP2 EP1 EP0
Note1
Description
This command is used to define area of frame memory where MCU can access. This command makes no change on the
other driver status. The values of SP [15:0] and EP [15:0] are referred when RAMWR command comes. Each value
represents one Page line in the Frame Memory.
SP[15:0]
EP[15:0]
X = Don’t care
Restriction
SP [15:0] always must be equal to or less than EP [15:0]
Note 1: When SP [15:0] or EP [15:0] is greater than 013Fh (When MADCTL’s B5 = 0) or 00EFh (When MADCTL’s B5 = 1),
data of out of range will be ignored.
Register
Availability
Status Availability
Normal Mode On, Idle Mode Off, Sleep Out Yes
Normal Mode On, Idle Mode On, Sleep Out Yes
Partial Mode On, Idle Mode Off, Sleep Out Yes
Partial Mode On, Idle Mode On, Sleep Out Yes
Sleep In Yes
Default
Status Default Value
Power On Sequence SP [15:0]=0000h EP [15:0]=013Fh
SW Reset SP [15:0]=0000h
If MADCTL’s B5 = 0: EP [15:0]=013Fh
If MADCTL’s B5 = 1: EP [15:0]=00EFh
HW Reset SP [15:0]=0000h EP [15:0]=013Fh