Data Sheet

a-Si TFT LCD Single Chip Driver
240RGBx320 Resolution and 262K color
ILI9341
The information contained herein is the exclusive property of ILI Technology Corp. and shall not be distributed,
reproduced, or disclosed in whole or in part without prior written permission of ILI Technology Corp.
Page 115 of 233
8.2.23. Color Set (2Dh)
2Dh RGBSET (Color Set)
D/CX RDX WRX D17-8 D7 D6 D5 D4 D3 D2 D1 D0 HEX
Command 0 1 ↑ XX 0 0 1 0 1 1 0 1 2Dh
1
st
Parameter 1 1 ↑ XX 0 0 R00 [5:0] XX
n
th
Parameter 1 1 ↑ XX 0 0 Rnn [5:0] XX
32
nd
Parameter 1 1 ↑ XX 0 0 R31 [5:0] XX
33
rd
Parameter 1 1 ↑ XX 0 0 G00 [5:0] XX
n
th
Parameter 1 1 ↑ XX 0 0 Gnn [5:0] XX
96
th
Parameter 1 1 ↑ XX 0 0 G64 [5:0] XX
97
th
Parameter 1 1 ↑ XX 0 0 B00 [5:0] XX
n
th
Parameter 1 1 ↑ XX 0 0 Bnn [5:0] XX
128
th
Parameter 1 1 ↑ XX 0 0 B31 [5:0] XX
Description
This command is used to define the LUT for 16-bit to 18-bit color depth conversion.
128 bytes must be written to the LUT regardless of the color mode. Only the values in Section 7.4 are referred.
This command has no effect on other commands, parameter and contents of frame memory. Visible change takes effect
next time the frame memory is written to.
Restriction
Register
Availability
Status Availability
Normal Mode On, Idle Mode Off, Sleep Out Yes
Normal Mode On, Idle Mode On, Sleep Out Yes
Partial Mode On, Idle Mode Off, Sleep Out Yes
Partial Mode On, Idle Mode On, Sleep Out Yes
Sleep In Yes
Default
Status Default Value
Power On Sequence Random values
SW Reset Contents of LUT protected
HW Reset Random values
Flow Chart
RGBSET (2Dh)
1st Parameter: R00[5:0]
:
32nd Parameter: R31[5:0]
33rd Parameter: G00[5:0]
:
96th Parameter: G63[5:0]
97th Parameter: B00[5:0]
:
128th Parameter: B31[5:0]
Command
Parameter
Action
Mode
Legend
Sequential transfer
Display