Data Sheet


RELIABILITY TEST
No. Test Item Test Condition Inspection after test
1 High Temperature Storage
802/96 hours
2 Low Temperature Storage
-302/96 hours
3 High Temperature Operating
702/96 hours
4 Low Temperature Operating
-202/96 hours
5 Temperature Cycle
-302~25~80210cycles
6DampProofTest
60590%RH/96 hours
7 Vibration Test
Frequency10Hz~55Hz~10Hz
Amplitude1.5mm,
XYZ direction for total 3hours
(Packing condition)
8
Drooping test
Drop to the ground from 1m height, one
time, every side of carton.
(Packing condition)
9
ESD test
Voltage:±8KV R: 330Ω C: 150pF
Air discharge, 10time
10
Hitting test
1,000,000 times in the same point,
Hitting pad: tip R3.75 mm,Silicone
rubber, Hardness:40 deg.; Load: 2.45N;
Hitting speed: Twice/sec; Electric load:
None;
Test area should be at 1.8 mm inside of
insulation.
11
Pen sliding durability test
100, 000 times minimum
Hitting pad: tip R0.8 mm Plastic pen;
Load: 1.47N; Sliding speed: 60 mm/sec;
Electric load: None
Test area should be at 1.8 mm inside of
insulation.
Inspection after 2~4hours
storage at room
temperature, the sample
shall be free from defects:
1.Air bubble in the LCD;
2.Sealleak;
3.Non-display;
4.missing segments;
5.Glass crack;
6.Current Idd is twice
higher than initial value.
7. The surface shall be free
from damage.
8.Linearity must be no
more than 1.5% by the
linearity tester.
9..The Electric charact
eristics requirements shall
be satisfied.
Remark:
1.The test samples should be applied to only one test item.
2.Sample size for each test item is 5~10pcs.
3.For Damp Proof Test, Pure water(Resistance10MΩ) should be used.
4.In case of malfunction defect caused by ESD damage, if it would be recovered to normal state after resetting, it
would be judge as a good part.
5.EL evaluation should be excepted from reliability test with humidity and temperature: Some defects such as
black spot/blemish can happen by natural chemical reaction with humidity and Fluorescence EL has.
6.Failure Judgment Criterion: Basic Specification, Electrical Characteristic, Mechanical Characteristic, Optical
Characteristic.
P.20
MULTI-INNO TECHNOLOGY CO.,LTD.
MODULE NO.: MI0283QT-11
Ver 1.2