Data Sheet

a-Si TFT LCD Single Chip Driver
240RGBx320 Resolution and 262K color
ILI9341
The information contained herein is the exclusive property of ILI Technology Corp. and shall not be distributed,
reproduced, or disclosed in whole or in part without prior written permission of ILI Technology Corp.
Page 206 of 233
12. Power ON/OFF Sequence
VDDI and VCI can be applied in any order.
VCI and VDDI can be powered down in any order.
During power off, if LCD is in the Sleep Out mode, VCI and VDDI must be powered down minimum
120msec after RESX has been released.
During power off, if LCD is in the Sleep In mode, VDDI or VCI can be powered down minimum 0msec after
RESX has been released.
CSX can be applied at any timing or can be permanently grounded. RESX has priority over CSX.
Note 1: There will be no damage to the display module if the power sequences are not met.
Note 2: There will be no abnormal visible effects on the display panel during the Power On/Off Sequences.
Note 3: There will be no abnormal visible effects on the display between end of Power On Sequence and before
receiving Sleep Out command. Also between receiving Sleep In command and Power Off Sequence.
Note 4: If RESX line is not held stable by host during Power On Sequence as defined in Sections 12.1 and 12.2,
then it will be necessary to apply a Hardware Reset (RESX) after Host Power On Sequence is complete
to ensure correct operation. Otherwise function is not guaranteed.
12.1. Case 1 – RESX line is held High or Unstable by Host at Power ON
If RESX line is held High or unstable by the host during Power On, then a Hardware Reset must be applied after
both VCI and VDDI have been applied – otherwise correct functionality is not guaranteed. There is no timing
restriction upon this hardware reset.
Note 1: Unless otherwise specified, timings herein show cross point at 50% of signal power level.