Data Sheet

Digital #4 - This is the uSD CS (chip select pin). It's used by the Arduino to tell the uSD that it

wants to send/receive data from the uSD only

Using with an Uno

Because the TFT is about the same size as an Arduino, we pre-assemble the shield in the factory.

To use, simply place it onto your Arduino Uno/Duemilanove/compatible. No wiring, no soldering!

Bam!

Using with a Mega/Leonardo

With just a little effort you can make this shield plug-n-play with the Mega/Leonardo. Look at the

bottom of the shield and find the area with the 6 jumpers. Three of them are closed, and three are

open. Solder close the three ICSP jumpers.