Datasheet

Pinouts
The TSL2591 is a I2C sensor. That means it uses the two I2C data/clock wires available on
most microcontrollers, and can share those pins with other sensors as long as they don't
have an address collision. For future reference, the I2C address is 0x29 and you can't
change it!
Power Pins:
Vin - this is the power pin. Since the chip uses 3 VDC, we have included a voltage
regulator on board that will take 3-5VDC and safely convert it down. To power the
board, give it the same power as the logic level of your microcontroller - e.g. for a 5V
micro like Arduino, use 5V
3vo - this is the 3.3V output from the voltage regulator, you can grab up to 100mA
from this if you like
GND - common ground for power and logic
(http://adafru.it/dGy)I2C Logic pins:
SCL - I2C clock pin, connect to your microcontrollers I2C clock line.
© Adafruit Industries https://learn.adafruit.com/adafruit-tsl2591 Page 6 of 22