Datasheet

If you are powering your project from USB, solder the USB A jack in (a 3-minute soldering

task). Then choose either JST for input (JST is often used for our LiIon batteries, but the

connector is only rated for 2A) or a terminal block.

If you would like to use another terminal block for output, pick up a 3.5mm 2pin block

here (http://adafru.it/duR) and solder to the output spot where the USB jack would go. Or

don't solder any connectors in for a more compact power pack and go with 22AWG wires

soldered directly in.