Datasheet

You can use a thinner wire for
data, in this case we have a
~22AWG data line. It's soldered
onto the out pin here
You may also want a thin wire for
your microcontroller ground,
especially if you are going to
power the Pixies seperately
We suggest doing up one Pixie,
then testing it. Once you know
you're good to go, disconnect it
from power and data and solder
additional Pixies
(please note, in this photo, the
green wire is connected to the
output! Just check your Pixies
before connecting)
© Adafruit Industries https://learn.adafruit.com/pixie-3-watt-smart-chainable-led-pixels Page 20 of 27