Datasheet
Table Of Contents
- Guide Contents
- Overview
- Pinouts
- Power Pins
- Logic pins
- Serial pins
- I2C & SPI pins
- GPIO pins
- Analog Pins
- Other control pins
- NC Pins
- Assembly
- Header Options!
- Soldering in Plain Headers
- Soldering on Female Header
- Power Management
- Battery + USB Power
- Power supplies
- Measuring Battery
- ENable pin
- Using NodeMCU Lua
- Open up serial console
- Hello world!
- Scanning & Connecting to WiFi
- WebClient example
- Using Arduino IDE
- Install the Arduino IDE 1.6.8 or greater
- Setup ESP8266 Support
- Blink Test
- Connecting via WiFi
- Downloads
- Datasheets & Files
- More info about the ESP8266
- Schematic
- Fabrication Print
- ESP8266 F.A.Q.
- When I connect stuff to some of the pins, the Huzzah stops working. Whats up with that?
- My Huzzah board keeps crashing and resetting, whats up with that?
- I can't seem to find the Serial port on my computer for the Feather HUZZAH?
- I still can't seem to find the Serial port on my computer for the Feather Huzzah!
- So, I’m getting a 'no such file' error compiling for ESP8266 on my Mac
- Whenever I start or reset the ESP8226 there's a bunch of "gibberish" on the Serial console
- I'm having difficulties uploading to the HUZZAH with the Arduino IDE
- I tried that, but I'm still having difficulties uploading with the Arduino IDE
- I'm stuck in bootloader mode and can't upload
- I can't get Lua to respond to my commands
Add the breakout board:
Place the breakout board over the pins so that the short
pins poke through the breakout pads
And Solder!
Be sure to solder all pins for reliable electrical contact.
(For tips on soldering, be sure to check out our Guide to
Excellent Soldering
(https://adafru.it/aTk)
).
© Adafruit Industries https://learn.adafruit.com/adafruit-feather-huzzah-esp8266 Page 17 of 42