Datasheet
Table Of Contents
- Guide Contents
- Overview
- Pinouts
- Power Pins
- Logic pins
- Serial pins
- I2C & SPI pins
- GPIO pins
- Analog Pins
- Other control pins
- NC Pins
- Assembly
- Header Options!
- Soldering in Plain Headers
- Soldering on Female Header
- Power Management
- Battery + USB Power
- Power supplies
- Measuring Battery
- ENable pin
- Using NodeMCU Lua
- Open up serial console
- Hello world!
- Scanning & Connecting to WiFi
- WebClient example
- Using Arduino IDE
- Install the Arduino IDE 1.6.8 or greater
- Setup ESP8266 Support
- Blink Test
- Connecting via WiFi
- Downloads
- Datasheets & Files
- More info about the ESP8266
- Schematic
- Fabrication Print
- ESP8266 F.A.Q.
- When I connect stuff to some of the pins, the Huzzah stops working. Whats up with that?
- My Huzzah board keeps crashing and resetting, whats up with that?
- I can't seem to find the Serial port on my computer for the Feather HUZZAH?
- I still can't seem to find the Serial port on my computer for the Feather Huzzah!
- So, I’m getting a 'no such file' error compiling for ESP8266 on my Mac
- Whenever I start or reset the ESP8226 there's a bunch of "gibberish" on the Serial console
- I'm having difficulties uploading to the HUZZAH with the Arduino IDE
- I tried that, but I'm still having difficulties uploading with the Arduino IDE
- I'm stuck in bootloader mode and can't upload
- I can't get Lua to respond to my commands
Here's some handy specs!
Measures 2.0" x 0.9" x 0.28" (51mm x 23mm x 8mm) without headers soldered in
Light as a (large?) feather - 6 grams
ESP8266 @ 80MHz or 160 MHz with 3.3V logic/power
4MB of FLASH (32 MBit)
3.3V regulator with 500mA peak current output
CP2104 USB-Serial converter onboard with 921600 max baudrate for uploading
Auto-reset support for getting into bootload mode before firmware upload
9 GPIO pins - can also be used as I2C and SPI
1 x analog inputs 1.0V max
Built in 100mA lipoly charger with charging status indicator LED
Pin #0 red LED for general purpose blinking. Pin #2 blue LED for bootloading debug & general purpose blinking
Power/enable pin
4 mounting holes
Reset button
Comes fully assembled and tested, with a USB interface that lets you quickly use it with the Arduino IDE or NodeMCU
Lua. (It comes preprogrammed with the Lua interpretter) We also toss in some header so you can solder it in and plug
into a solderless breadboard. Lipoly battery and USB cable not included (but we do have lots of options in the shop if
you'd like!)
© Adafruit Industries https://learn.adafruit.com/adafruit-feather-huzzah-esp8266 Page 7 of 42