Datasheet
Table Of Contents
- Guide Contents
- Overview
- Pinouts
- Power Pins
- Logic pins
- Serial pins
- I2C & SPI pins
- GPIO pins
- Analog Pins
- Other control pins
- NC Pins
- Assembly
- Header Options!
- Soldering in Plain Headers
- Soldering on Female Header
- Power Management
- Battery + USB Power
- Power supplies
- Measuring Battery
- ENable pin
- Using NodeMCU Lua
- Open up serial console
- Hello world!
- Scanning & Connecting to WiFi
- WebClient example
- Using Arduino IDE
- Install the Arduino IDE 1.6.8 or greater
- Setup ESP8266 Support
- Blink Test
- Connecting via WiFi
- Downloads
- Datasheets & Files
- More info about the ESP8266
- Schematic
- Fabrication Print
- ESP8266 F.A.Q.
- When I connect stuff to some of the pins, the Huzzah stops working. Whats up with that?
- My Huzzah board keeps crashing and resetting, whats up with that?
- I can't seem to find the Serial port on my computer for the Feather HUZZAH?
- I still can't seem to find the Serial port on my computer for the Feather Huzzah!
- So, I’m getting a 'no such file' error compiling for ESP8266 on my Mac
- Whenever I start or reset the ESP8226 there's a bunch of "gibberish" on the Serial console
- I'm having difficulties uploading to the HUZZAH with the Arduino IDE
- I tried that, but I'm still having difficulties uploading with the Arduino IDE
- I'm stuck in bootloader mode and can't upload
- I can't get Lua to respond to my commands
Power Pins
GND - this is the common ground for all power and logic
BAT - this is the positive voltage to/from the JST jack for the optional Lipoly battery
USB - this is the positive voltage to/from the micro USB jack if connected
EN - this is the 3.3V regulator's enable pin. It's pulled up, so connect to ground to disable the 3.3V regulator
3V - this is the output from the 3.3V regulator, it can supply 500mA peak (try to keep your current draw under
250mA so you have plenty for the ESP8266's power requirements!)
Logic pins
This is the general purpose I/O pin set for the microcontroller. All logic is 3.3V
Serial pins
The ESP8266 runs on 3.3V power and logic, and unless otherwise specified, GPIO pins are not 5V safe! The
analog pin is also 1.0V max!
© Adafruit Industries https://learn.adafruit.com/adafruit-feather-huzzah-esp8266 Page 9 of 42