Datasheet

This is the FeatherWing Doubler - a prototyping add-on and more for

all Feather boards. This is similar to the FeatherWing Proto except

there are two! The magic of the Doubler comes when stacking a

Feather and another board on top of the Doubler so you can work with

both boards simultaneously side-by-side.

Included:

 1 Doubler PCB

 1 set Feather Stacking Headers (you can cut these down after

soldering so they aren't stacking-style if you want a slimmer

build)

 1 set Feather Female Headers

PAGE 1
This is the FeatherWing Doubler - a prototyping add-on and more for all Feather boards. This is similar to the FeatherWing Proto except there are two! The magic of the Doubler comes when stacking a Feather and another board on top of the Doubler so you can work with both boards simultaneously side-by-side.
PAGE 2
The Doubler, like the Proto, has a duplicate breakout for each pin on a Feather, as well as a bunch of plain grid proto holes. Also, the two sets of pins are cross connected and for GND and 3.3V, giving you a full strip of connected pads. You'll need to solder on the female headers and/or stacking headers however you like, the Doubler comes as a mini kit! Check out our range of Feather boards here.  PCB Dimensions: 50.9mm x 47mm x 1.6mm / 2" x 1.85" x 0.06"  Weight: 6.