Datasheet

Hardware

The following commands allow you to interact with the low level HW on the Bluefruit LE

module, such as reading or toggling the GPIO pins, performing an ADC conversion ,etc.:

AT+BAUDRATE

Changes the baud rate used by the HW UART peripheral on the nRF51822.

Codebase Revision: 0.7.0

Parameters: Baud rate, which must be one of the following values:

1200

2400

4800

9600

14400

19200

28800

38400

57600

76800

115200

230400

250000

460800

921600

1000000

Output: The current baud rate

# Set the baud rate to 115200

AT+BAUDRATE=115200

# Check the current baud rate

AT+BAUDRATE

115200