Datasheet

AT+EDDYSTONEURL

This command will set the URL for the Eddystone-URL protocol.

Codebase Revision: 0.6.6

Parameters:

The URL to encode (mandatory)

An optional second parameter indicates whether to continue advertising the Eddystone

URL even when the peripheral is connected to a central device

Firmware 0.6.7 added an optional third parameter for the RSSI at 0 meters value. This

should be measured by the end user by checking the RSSI value on the receiving

device at 1m and then adding 41 to that value (to compensate for the signal strength

loss over 1m), so an RSSI of -62 at 1m would mean that you should enter -21 as the RSSI

at 0m. Default value is -18dBm.

Output: Firmware <= 0.6.6: none. With firmware >= 0.6.7 running this command with no

parameters will return the current URL.

AT+EDDYSTONECONFIGEN

This command causes the Bluefruit LE module to enable the Eddystone URL config service

for the specified number of seconds.

# Enable Eddystone support

AT+EDDYSTONEENABLE=1

# Check the current Eddystone status on the module

AT+EDDYSTONEENABLE

# Set the Eddystone URL to adafruit

AT+EDDYSTONEURL=http://www.adafruit.com

# Set the Eddystone URL to adafruit and advertise it even when connected

AT+EDDYSTONEURL=http://www.adafruit.com,1