Datasheet

Send a MIDI event

AT+BLEMIDIRX

Receive an available MIDI event

AT+GATTCHARRAW

Added this read only command to read binary (instead of ASCII) data from a

characteristic. It is non-printable but less overhead and easier for writing library in

Arduino

AT+NVMWRITE=offset,datatype,data

Writes data to 256 byte user NVM. Datatype must be STRING (1), BYTEARRAY (2), or

INTEGER (3)

AT+NVMREAD=offset,size,datatype

Reads data back from 256 bytes user NVM

AT+NVMREADRAW=offset,size binary data

Binary data (instead of ASCII) is returned, ending with "OK\r\n". It is non-printable but

less overhead and easier to use in some situations.

AT+BLEHIDGAMEPAD=x,y,buttons

X is LEFT, RIGHT: X=-1 LEFT is pressed, X=1 RIGHT is pressed, X=0 no pressed

Y is UP, DOWN: Y=-1 i UP, Y=1 is DOWN, Y=0 no pressed

Button [0x00-0xFF] is a bit mask for 8 button 0-7

AT+GAPCONNECTABLE=on/off/1/0

Allow/disallow connection to the device

AT+EDDYSTONESERVICEEN

Add/remove EddyStone service to GATT table (requires reset)

AT+EDDYSTONEBROADCAST=on/off/0/1

Start/stop broadcasting url using settings from NVM

AT+BLEBATTEN=on/off/1/0

Enable battery service. Reset required due to the service change.

AT+BLEBATTVAL=percent

Updates the Battery level, percent is 0 to 100

The following commands were changed in the 0.7.0 release:

AT+GATTADDCHAR

Added a DATATYPE option to indicate the data type for the GATT characteristic's

payload. Valid option are: AUTO (0, default), STRING (1), BYTEARRAY (2),

INTEGER (3)

Added characteristic user description option via the DESCRIPTION flag

Added characteristic presentation format support via the PRESENTATION flag