Datasheet

Fixed a bug with AT+GATTCHAR max_len value not being taken into account after a

reset (min_len was always used when repopulating the value)

Version 0.6.2

This is the first release targetting 32KB SRAM parts (QFAC). 16KB SRAM parts can't be used

with this firmware due to memory management issues, and should use the earlier 0.5.0

firmware.

The following AT commands were changed in the 0.6.2 release:

AT+BLEUARTTX

Basic escape codes were added for new lines, tabs and backspace

AT+BLEKEYBOARD

Also works with OS X now, and

may

function with other operating systems that support

BLE HID keyboards

Version 0.5.0

The following AT commands were added in the 0.5.0 release:

AT+BLEKEYBOARDEN

AT+BLEKEYBOARD

AT+BLEKEYBOARDCODE

The following AT commands were changed in the 0.5.0 release:

ATI

The SoftDevice, SoftDevice version and bootloader version were added as a new (7th)

record. For Ex: "S110 7.1.0, 0.0" indicates version 7.1.0 of the S110 softdevice is used

with the 0.0 bootloader (future boards will use a newer 0.1 bootloader).

Other notes concerning 0.5.0:

Starting with version 0.5.0, you can execute the AT+FACTORYRESET command at any point

(and without a terminal emulator) by holding the DFU button down for 10 seconds until the

blue CONNECTED LED starts flashing, then releasing it.

Version 0.4.7

The following AT commands were added in the 0.4.7 release: