Datasheet

The AM2302 is a wired version of the DHT22, in a large plastic body. It

is a basic, low-cost digital temperature and humidity sensor. It uses a

capacitive humidity sensor and a thermistor to measure the

surrounding air, and outputs a digital signal on the data pin (no

analogue input pins needed). It’s fairly simple to use, but requires

careful timing to grab data. The only real downside of this sensor is

you can only get new data from it once every 2 seconds, so when using

our library, sensor readings can be up to 2 seconds old.

PAGE 1
The AM2302 is a wired version of the DHT22, in a large plastic body. It is a basic, low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and outputs a digital signal on the data pin (no analogue input pins needed). It’s fairly simple to use, but requires careful timing to grab data.
PAGE 2
Simply connect the red 3-5V power, the yellow wire to your data input pin and the black wire to ground. Although it uses a single-wire to send data it is not Dallas One Wire compatible! If you want multiple sensors, each one must have its own data pin. Compared to the DHT11, this sensor is more precise, more accurate and works in a bigger range of temperature/humidity, but its larger and more expensive There is a 5.