User Manual

You're done with the header strip! Check your solder

joints visually.

Prepare the terminal block:

Place the terminal block inside the board. Make sure it's facing out! Turn the board over so the terminal pins are facing

upwards.

Solder again!

First solder one pin by using the soldering iron to prop

up the board. Then use a vice (https://adafru.it/dDJ) or

helper hands to hold the board in place while soldering

the other pin.

https://learn.adafruit.com/adafruit-ina260-current-voltage-power-sensor-

breakout

Page 10 of 24