Datasheet

Assembly

1: Attach BeagleBone to Base Plate

Insert 4 screws into the BeagleBone's corner mounting holes:

Flip the board over, using fingers and thumb to hold the screws in place. If this is a dexterity

challenge, the screws can also be held with tape:

Slide a nylon spacer over each of the four screws. VERY IMPORTANT: Use ONLY the

spacers included with the kit. DO NOT use wider standoffs or spacers in their

place, and SUPER ESPECIALLY DO NOT use hex-nuts as a makeshift

standoff/spacer. The component clearances on the BeagleBone are very close,

and using the wrong spacers could result in compo nents being crushed!