Datasheet

Slide the base plate over the screws, coming to rest on the spacers. There's a specific

orientation for the base plate: one of the four alignment studs is smaller than the others — this

should be positioned closest to the USB client port.

Install four nuts and gently tighten each screw.

You can now reinstall the proto cape, if using one.

2: Assemble Case Sides

The case is held together using "T-slot" construction. Holding one of the side pieces, insert a

nut into the cross part of the "T" (tape can again provide a temporary hold if needed).

Position one of the end pieces over the alignment studs, then insert a screw through the

corresponding hole for the nut. Tighten with gentle finger pressure for now.