Datasheet

This is an add-on prototyping Pi Plate from Adafruit, which can snap

onto the Pi PCB (and is removable later if you wish) and gives you all

sorts of prototyping features to make building on top of the Pi super

easy.

Note: This kit is best used for the Raspberry Pi Model A or Model B. You

can use it with any "2x20 GPIO type" Pi (A+, B+, Zero, Pi 2, Pi 3) but

only the 'top 26 pins' will be broken out for use

There's a big prototyping area, half of which is 'breadboard' style and

half of which is 'perfboard' style so you can wire up DIP chips, sensors,

and the like. Along the edges of the proto area, all the GPIO/I2C/SPI

and power pins are broken out to 0.1" stips so you can easily connect

to them. On the edges of the prototyping area, (almost all of) the

breakout pins are also connected to labelled 3.5mm screw-terminal

PAGE 1
This is an add-on prototyping Pi Plate from Adafruit, which can snap onto the Pi PCB (and is removable later if you wish) and gives you all sorts of prototyping features to make building on top of the Pi super easy. Note: This kit is best used for the Raspberry Pi Model A or Model B.
PAGE 2
blocks. This makes it easy to semi-permanently wire in sensors, LEDs, etc. There's also a 4-block terminal block broken out to 0.1" pads for general non-GPIO wiring. Finally, there’s an SOIC surface mount chip breakout area, for those chips that don’t come in DIP format. This kit comes as a set of parts, a little soldering is required to put it together but it’s really easy, even a beginner can do it in 15-20 minutes or so.